Do you ever find yourself in a situation where only one of your AirPods works? It can be frustrating, especially when you’re in the middle of listening to your favorite podcast or music. But don’t worry, there are simple steps you can take to fix this issue and get both of your AirPods working again.
If you’re experiencing issues with one of your AirPods not working, there are a few basic troubleshooting steps you can try:
Check for Debris in Speaker Mesh
One common reason why an AirPod might stop working is because of debris in the speaker mesh. This can cause muffled audio or even no sound at all. Inspect the speaker mesh on each AirPod and gently brush away any dirt, earwax, or debris.
Clean Your AirPods and Charging Case
If debris is not the issue, your AirPods or charging case may need cleaning. Use a soft, dry cloth to wipe away any dirt or grime. For stubborn stains, you can use a slightly damp cloth or a small amount of rubbing alcohol.
Reset Your AirPods
If cleaning doesn’t solve the problem, try resetting your AirPods. Put them back in the charging case, close the lid, and wait for at least 15 seconds. Then, open the lid, press and hold the setup button on the back of the case until the status light flashes amber. Remember to re-pair your AirPods with your device after resetting them.
By following these basic troubleshooting steps, you can often fix issues with one of your AirPods not working.
If the basic troubleshooting steps didn’t work, here are some more advanced steps you can try:
Check Stereo Balance Settings
Sometimes, one AirPod may not work because the stereo balance is off. Check the stereo balance settings on your device and make sure the balance is set in the middle.
Check Accessibility Settings
Another reason one AirPod may not work is because of accessibility settings. Go to your device’s accessibility settings and make sure that Mono Audio is turned off.
Re-Pair Your AirPods
If your AirPods still aren’t working, try re-pairing them with your device. Forget your AirPods from the Bluetooth settings, put them back in the case, hold the setup button on the back until the status light flashes white, and go through the pairing process again.
Contact Apple Support
If none of the above steps work, it may be time to contact Apple Support. They can assist you further and determine if your AirPods need to be replaced or if there’s another issue that needs to be addressed.
Remember, if your AirPods are still under warranty or covered by AppleCare+, you may be eligible for a replacement. Be sure to check your warranty status before contacting Apple Support.
Why Does One Of My AirPods Not Work: Common Issues
If you’ve ever experienced one of your AirPods not working, you’re not alone. Here are some common issues that could be causing the problem:
One common reason for one AirPod not working is a low battery. Check the battery levels of both AirPods, and if one is significantly lower than the other, it’s likely the cause.
A connection problem between your AirPods and your device can also cause one of them not to work. Try toggling the Bluetooth connection off and on or resetting your AirPods.
If your AirPods are dirty, it could be causing one of them to not work properly. Gently wipe them with a soft, dry cloth and use a soft-bristled brush to remove debris from the speaker mesh.
Software glitches can also cause one AirPod to not work. Try resetting your AirPods or updating your device’s software. Contact Apple Support for further assistance if needed.
If you’re experiencing issues with one of your AirPods not working, try these steps before contacting Apple Support:
- Check the battery levels.
- Reset your AirPods.
- Clean your AirPods.
- Troubleshoot connection issues.
- Update your device’s software.
By following these steps, you can troubleshoot the issue with your AirPods and hopefully get them working again. Remember to take good care of your AirPods to prevent future issues from arising.